Product Information
API 5CT seamless casing pipe BTC
Section: Seamless and Weld
Standards:
ISO 11960:2004,Petroleum and natural gas industries-Steel pipes for use as casing tubing for wells
Sizes: Outside Diameter: 1.660"-30"
Grades: H40,J55,K55,N80,N80Q,L80,C90,C95,T95,P110,Q125,SS95,SS110,9%CR,13%CR
Some of the OCTG casing tubing available for your company’s requirements include:
General drill pipes,casing tubing conforming to API standards for oil field and deep well drilling
API H40 casing tubing – general purpose pipes conforming to API specification 5CT
API J55 general purpose pipes for casing tubing applications,similar to specification K55 with lower minimum tensile strength conforming to API specification 5CT
API K55 general purpose pipes used primarily in casings conforming to API specification 5CT
API L80 casing tubing conforming to API specification 5CT with a controlled yield strength with hardness test requirement of 23 HRC maximum; usually used in wells with sour (H2S) environments or deep sour wells
API N80 or N80 Q&T (Quench and Tempered) – general purpose pipe manufactured to API specification 5CT
API Normalized N80 – lower-cost alternative to standard Q&T N80; pipe walls less than 0.500 inch; inspections,testing and dimensions are in accordance with API 5CT for grade N80. Charpy v-notch impact test absorbed energy results conform to API SR16 and are lower Q&T N80
API C90 – an API controlled yield strength grade (25.4 HRC maximum) generally used in sour condensate wells; with required extensive hardness testing,SSCC testing per NACE Standard TM-0177-Method A; minimum threshold stress required is 80% of specified minimum yield strength
API C95 – same strength range as T95 and U. S. Steel C95,but without a hardness requirement; generally not used in sour wells
API T95 – API controlled yield strength grade (25.4 HRC maximum),the same as API C95 and U. S. Steel C95; generally for use in sour condensate wells; extensive hardness testing is required including SSCC testing per NACE Standard TM-0177-Method A; minimum threshold stress required is 80% of specified minimum yield strength
API P110 – generally used in deep wells; this grade is not suitable for most sour condensate wells
API Q125 – API grade for deep well service,generally not for use in sour condensate wells; quadrant hardness testing is required (no specified hardness limits other than the variation between readings); impact testing required for each heat and/or lot; typically EMI and UT NDT inspections are required
Connections:
STC (short round thread casing)
LTC (long round thread casing)
BTC (buttress thread casing)
XL (extreme-line casing)
Premium Connections
VAM,VAMTOP,NEW VAM
And almost any premium & gas tight connection
Length: Range 1,Range 2 & Range 3:
Applicable Tests: See our Standard Inspection Scope
Protection:
External bare and uncoated or externally coated with black/ transparent anti rust Mill varnish
Plastic or Metal Pin and Box Protectors.
Internal plastic coating or sleeves.
Mill Test Certificates:
Issued in accordance with API Specification 5CT Eighth Edition
Additional Third Party Inspection can also be performed on request.
Consultation
