High Efficiency Boiler Economizer
Application
Spirally Wound High Frequency Resistance Welded Finned Tubes are used in Heat Recovery Systems associated with Furnaces for Petrochemicals applications, and with Boilers for Power Generation and Waste Heat Recovery applications. The usage of finned tubes in Heat Exchangers reduce cost and size of the equipment which directly results in performance improvement.
Manufacturing Process
The High Frequency Resistance Welding process usually employs 400, 000 Hz current. With this technique, the fin is wound on edge around the tube spiraly and a continuous weld is obtained.
The High Frequency Resistance Welding process produces a strong metallurgical bond between the fin and the tube while minimizing the heat affected zone (HAZ) in the tube.
PROGEN follows International Standards for Dimensions, Tolerances and Tests for High Frequency Resistance Welded Finned Tubes.
Product Specification:
Fin Height: 0.32" – 1.0" (8.0mm – 25.4mm) Fin Height: 0.50" – 1.50" (12.7mm – 38.1mm)
Fin Thk: 0.04" – 0.11" (1.0 – 2.7mm) Fin Thk: 0.04" – 0.11" (1.0mm – 2.7mm)
Fin Spacing: 1 – 6 per inch (39 – 236 per metre) Fin Spacing: 1 – 6 per inch (39 – 236 per metre)
Tube Outer Dia: 1" – 6" (25mm – 152.4mm) Diagram Tube Outer Dia: 1" – 6" (25mm – 152.4mm)
Segment Width: 5/32",5/16" (4.5mm, 8.0mm)
Overall Tube Length: 18 Mtrs
Tube & Fin Material: Carbon Steel, Alloy Steel, Stainless Steel (Any Combination)
Type of Tube: Welded (or) Seamless
Tube Ends: Straight (or) Bent
Details Required for Enquiry:
Bare Tube: OD, Thickness, Length & Specification/Material
Fin: Thickness, Height, Fin Spacing (Pitch), Fin Length & Specification/Material
Fin Type: Plain or Segmented. If Segmented, Segment width and depth
Edge Preparation:
Square Ends, Bevelled Ends, Straight or Bent.
